page 1 of 3 www.aecsensors.com sales department tel: (888) 847-6552 dg19 pcb automotive / industrial relay contacts contact number & arrangement spst-no (1 form a), spst-nc (1 form b), spdt (1 form c) contact material agni0.15, agni90/10, agsnoino, agsno 2 , agcdo max. switching voltage dc 30vdc - current dependent - see fig 4 min. switching current / voltage 0.01a/12vdc (agni0.15), 0.5a/5vdc (agsnoino) 1 form a 1 form b 1 form c no nc max. continuous current dc1 45a (agsnoino) 40a (agsno 2 ) 30a 45a (agsnoino) 40a (agsno 2 ) 30a max. switching current make 180a (agsnoino) 100a 30a 180a (agsnoino) 100a 30a break 60a 30a 60a 30a initial resistance 100m?, max. at 0.1a/6vdc coil rated voltage dc 6, 12, 24v must release voltage 10% u n operating range of supply voltage see coil table 1 rated power consumption dc 1.5w approx. insulation insulation resistance 100m? at 500vdc, 50%rh dielectric strength coil to contact 500vrms, 1 min. general data operating time (typical) ms 5 release time (typical) ms 3 electrical life ops 2 x 10 5 (see note 2) mechanical life ops 1 x 10 7 dimensions l x w x h various - see dimensions fig.1 weight open: 18g / covered: 23g approx. ambient temperature storage -40 to +155c operating -40 to 125c (higher to special order) shock resistance functional: 20g 11ms; destructive: 100g vibration resistance functional: no 20g; nc 10g 20-200hz drop resistance 1m height drop on concrete in fnal enclosure ? 30a to 45a continuous current capacity ? agsnoino contacts for motor & lamp loads ? open, dust cover and sealed versions ? us & european terminal confgurations ? automotive oriented design ref: dg19 051216jhm rohs compliant specifcations are subject to change without notice. e&oe.
ordering codes type contact material contact arrangement cover protection and mounting coil code options d g 1 9 - - 5 - - contact material 10 - agcdo see coil table 1 20 - agni (90/10) 30 - agsno 2 ** 70 - agsnoino 80 - agni 0.15 contact arrangement 11 - spdt (1 c/o, 1 form c) 21 - spst-no (1n/o, 1 form a) 31 - spst-nc (1n/c, 1 form b) cover protection category 1 - no cover, ip00 3 - in cover, sealed - ip67 7 - in cover, dust cover - ip54 connection mode 5 - for pcb footprint style 11 - european footprint / pin confguration 81 - us footprint / pin confguration (covered style with 1 less terminal - see fig. 2) 81d - old us covered footprint / pin confguration with extra terminal (fig. 3) dg19 pcb automotive / industrial relay ref: dg19 051216jhm coil data table 1 coil voltage code nominal voltage (vdc) coil resistance (?) 10% at 20c must operate voltage max. (vdc) max.allowable voltage (vdc)* must release voltage min. (vdc) 1006 6 19 3.3 8 0.6 1012 12 90 6.8 16 1.2 1024 24 362 13.9 31 2.4 * at ambient temperature of 85c, maximum allowable voltage should be reduced to 72% page 2 of 3 www.aecsensors.com sales department tel: (888) 847-6552 specifcations are subject to change without notice. e&oe. notes: ** contact rating for spdt dg19-3011-*5-****-** is 40a for the normally open contact and 30a for the normally closed contact, but is marked 30a 14vdc to avoid inadvertent application of too much current on the normally closed contact.
dg19 pcb automotive relay american electronic components inc., 1101 lafayette st. elkhart, in46516 page 3 of 3 www.aecsensors.com sales department tel: (888) 847-6552 overall dimensions fig. 1 wiring diagrams fig. 2 (bottom view) dimensions in mm reference curves fig.4 specifcations are subject to change without notice. e&oe. ref: dg19 051216jhm notes: 1: all parameters, unless otherwise specifed, are measured at ambient temperature of 23 o c. 2: electrical life obtained at resistive or inductive load at 40a, 13.5vdc, with suitable arc suppression circuit attached and with operating frequency of 1 op/sec. 3: maximum make current refers to lamp load inrush current. consult factory for motor and capacitive loads. 4: for optimum electrical life, please remove the knock off nib of the sealed version after cleaning process. open frame covered pcb mounting dimensions (bottom view) us footprint european footprint us footprint european footprint us footprint us footprint european footprint european footprint % nominal coil voltage max. dc resistive load breaking capacity spst-no spst-nc spdt 3 .3mi n 2. 2 3. 4 3. 3 2. 2 2. 2 2. 4 2. 3 2. 3 2. 2 2. 2 3. 6 6. 4 3. 3 2. 2 4. 4 6. 4 max:allowable ambient temperature ( o c) max:allowable ambient temperatur e switching current (a) vdc switching voltage * * * * terminal not ftted for standard us covered style 2. 2 4. 4 6. 4 old us style covered fig. 3 available to special order only - option 81d (moq will apply) e.g dg19-3011-35-1012-81d
|
